Devolo dlan pro 1200+ wifi ac - Starter Kit and Single Kit-Setting up a New Dlan Pro Network

Initial use 27
devolo dLAN pro 1200+ WiFi ac
dLAN pro 1200+ WiFi ac either manually or using
the WiFi Clone function on the configuration
interface.
More information on the function and activa-
tion of WiFi Clone can be found in Chapter
4.4.2 Network settings  Access point –
Settings.
To integrate the
dLAN pro 1200+ WiFi ac into an ex-
isting Wi-Fi network with dLAN pro
wireless devices of the 500 series
(e.g. dLAN pro 500 Wireless+), you
have to transfer the settings of your
existing Wi-Fi configuration manually
to the configuration interface of the
dLAN pro 1200+ WiFi ac.
For more information on the configuration in-
terface, refer to Chapter 4 Network configu-
ration.
3.4.2 Starter Kit and Single Kit—Setting
up a new dLAN pro network
햲 Connect the dLAN pro 1200+ to your Internet
access device's network jack.
햳 Plug the dLAN pro 1200+ WiFi ac into a wall
socket. The device is ready to operate once the
indicator light of the encryption button with the
home icon turns white (after approximately 45
seconds).
To disconnect the device from the
mains supply, unplug the device from
the electrical socket. The power out-
let and all connected network devic-
es should be easily accessible so that
you can pull the mains plug quickly if
needed.
Connecting the dLAN pro 1200+ and a
dLAN pro 1200+ WiFi ac as a dLAN pro network
Before you can use the device in a dLAN pro network,
first you have to connect it as a network. This is accom-
plished by using a shared dLAN password. This forms
a delimited dLAN pro network. Shared use of the dLAN
password serves as access control to the dLAN pro net-
work as well as the encryption, and thereby the inter-
ception protection, of the transmitted data.
The dLAN password can be set in different ways:
dLAN pro network encryption at the touch of a
button