Devolo dlan pro 1200+ wifi ac - VLAN and Multi-SSID

Network configuration 65
devolo dLAN pro 1200+ WiFi ac
Wi-Fi
In the example of building networking (see 2.5.2
dLAN pro 1200+ WiFi ac as a Wi-Fi client), you
can also implement a VLAN trunk using Client mode.
쎲 Tx Force Untag disabled = Rx Tagged Only
automatically active
쎲 If multiple VLANs are selected, Rx Tagged Only
is activated automatically. The PVID is adjusted
automatically.
쎲 If only one VLAN is selected, PVID takes the value
of the corresponding VLANs; if both are active,
there is no more PVID.
Under PVID, the Port VLAN ID is specified, which is
assigned to received "untagged" frames. In the Rx
setting, Tagged only is the configured PVID without
meaning.
Under Default Priority, the VLAN priority is speci-
fied, which is assigned to the received untagged
frames.
4.6.4 VLAN and multi-SSID
Using the functions VLAN and multi-SSID, the
dLAN pro 1200+ WiFi ac can establish more complex
network architectures. The following illustration shows
a network of four devices, three access points (SSIDs)
and four VLANs. The VLAN trunk is implemented via
dLAN. VLAN 1 remains the Management VLAN. To
eliminate unwanted access on the intranet and the
back-end, Ethernet ports in VLAN 2 are configured.
When a client connects to dLAN pro 1200+ WiFi ac via
Ethernet, it only has access to the Internet. Thus, the
configuration of the dLAN pro 1200+ WiFi ac is also
excluded via Ethernet. VLAN 2 (Internet), VLAN 3 (in-
tranet) and VLAN 4 (back-end) are made accessible to
clients via Wi-Fi.