Introduction 18
devolo Magic 1 WiFi
Before the networking procedure, write down the WiFi
key of the devolo Magic 1 WiFi. You can find the de-
vice's unique key on the label on the rear side of the
housing.
In order to connect the devolo Magic 1 WiFi with your
laptop, tablet or smartphone later via WiFi, enter the
noted WiFi key as the network security key.
In order to switch WiFi off, press and hold the WiFi
button longer than 3 seconds.
In order to switch WiFi back on, briefly tap the WiFi
button.
Connecting WiFi devices via WPS
If the device is still on factory defaults, tap the WiFi
button in order to activate WPS.
If the WiFi connection was switched off and you
would like to activate WPS, press the WiFi button
twice; once to switch WiFi on, and again to activate
WPS.
If the WiFi connection is switched on and you want
to copy these settings to another devolo Magic adap-
ter, continue reading with the Chapter 4.7.5 Config
Sync.
WPS is one of the encryption standards developed by
the WiFi Alliance. The objective of WPS is to make it
easier to add devices to an existing network. For more
detailed information, refer to Chapter 4.4.6 WiFi Pro-
tected Setup (WPS).
2.3.3 Reading the WiFi indicator light
The integrated WiFi indicator light (LED) shows the status
of the devolo Magic 1 WiFi by illuminating and/or flashing
WiFi-LED Flashing behavior Meaning LED status display (web
interface*)
1 White LED Flashes at intervals of
0,1 sec. on /5 sec. off
The devolo Magic adapter is in WPS
mode to integrate WiFi-enabled devices
via WPS.
Cannot be disabled
To Next Page
Loading...
Need help?
General
