45 Network configuration
devolo Magic 1 WiFi
4.7.2 Management
System information lets you enter user-defined names in
the Device name (hostname) and Device location fields.
Both pieces of information are particularly helpful if mul-
tiple devolo Magic adapters are to be used and identified
in the network.
Under Change access password, a login password can be
set for accessing the web interface.
By default, the built-in web interface of the
devolo Magic 1 WiFi is not protected by a password. We
recommend assigning a password when the installation of
the devolo Magic 1 WiFi is complete to protect it against
tampering by third parties.
To do so, enter the desired new password twice. Now
the web interface is protected against unauthorised
access with your custom password!
The Powerline standby settings let you enable PowerSa-
ve mode for the devolo Magic adapter.
If the Permit PowerSave mode option is enabled, the
devolo Magic 1 WiFi automatically switches to standby
mode after approximately 10 minutes if no Ethernet
connection is active, meaning that there is no active net-
work device (e.g. computer) connected to the network in-
terface.
In this mode, the devolo Magic adapter is not accessible
over the Powerline network. As soon as the network device
(e.g. computer) connected to the network interface is swit-
ched on again, your devolo Magic adapter can also be ac-
cessed over the electrical wiring again.
PowerSave mode is enabled in the devolo Magic adapter's
factory default condition.
The LED settings let you disable the LED status display of
the WiFi and Powerline LEDs. The brightness of the WiFi
LED can also be reduced so that the devolo Magic adapter
can act as a night light.
An error status is indicated by corresponding flashing be-
haviour regardless of this setting (see Chapter 2.3.1 Rea-
ding the PLC indicator light).
For information on the LED behaviour of the
devolo Magic adapter in standby mode, refer to
Chapter 2.3.1 Reading the PLC indicator light.
You can completely disable the operating buttons on the
devolo Magic adapter in order to protect yourself against
possible changes. Simply disable the Enable PLC button
or Enable WiFi button option.
The operating buttons are enabled in the devolo Magic ad-
apter's factory default condition.
Under Time zone, you can select the current time zone,
e.g. Europe/Berlin. The Time server (NTP) option lets you
To Next Page
Loading...
Need help?
General
