Initial use 26
devolo Magic 1 WiFi mini
If the LEDs on both devolo Magic adapters
light up in white, then your devolo Magic
network has been set up according to your
individual specifications and is protected
from unauthorised access.
3.3.2Addition – Expanding an existing
Powerline network by adding
another devolo Magic 1 WiFi mini
Before you can use the devolo Magic 1 WiFi mini in
your devolo Magic network, first you have to
connect it to your existing devolo Magic adapters
as a network. This is accomplished by using a
shared password.
1 Connect the devolo Magic 1 WiFi mini to the
network connection of your computer or ano-
ther network device using a network cable.
2 Plug the devolo Magic 1 WiFi mini into an
available power socket. As soon as the LED flas-
hes white at regular intervals of 0.5 seconds,
the adapter is ready to operate but not yet
integrated into a devolo Magic network (see
Chapter 2.3.1 Reading the Powerline indica-
tor light).
3 Within 3 minutes, press the Powerline button
on a devolo Magic adapter in your existing
devolo Magic network for approximately 1 sec.
The new devolo Magic adapter pairs automati-
cally so no button needs to be pressed. The LED
of this adapter now also flashes white.
If the LEDs light up white on both
devolo Magic adapters, the new adapter
has been successfully integrated into your
existing devolo Magic network.
For each pairing operation, only one additional
adapter can be added at a time.
3.3.3Changing the network password
A network password can also be changed in the
following ways:
b Using the web interface of the devolo Magic
adapter (see Chapter 4.5 Powerline)
or
b Using devolo Cockpit or the
devolo Home Networking App. For more
information, refer to the following chapter.
Magic_1_WiFi_mini.book Seite 26 Mittwoch, 16. Oktober 2019 11:27 11
To Next Page
Loading...
Need help?
General
Weight and Dimensions
