25 Initial use
devolo Magic 2 WiFi next
3.3.2Addition – Expanding an existing
PLC network by adding another
devolo Magic 2 WiFi next
Before you can use the devolo Magic 2 WiFi next
in your devolo Magic network, first you have to
connect it to your existing devolo Magic adapters
as a network. This is accomplished by using a sha-
red password.
1 Plug the devolo Magic 2 WiFi next into an
available power socket. As soon as the LED
flashes white at regular intervals of
0.5 seconds, the adapter is ready to operate
but not yet integrated into a devolo Magic
network (see Chapter 2.3.1 Reading the PLC
indicator light).
2 Within 3 minutes, press the PLC button on a
devolo Magic adapter in your existing
devolo Magic network for approximately 1 sec.
The new devolo Magic adapter pairs automati-
cally so no button needs to be pressed. The LED
of this adapter now also flashes white.
If the LEDs light up white on both
devolo Magic adapters, the new adapter
has been successfully integrated into your
existing devolo Magic network.
For each pairing operation, only one additional
adapter can be added at a time.
3.3.3Changing the network password
A network password can also be changed in the
following ways:
b Using the web interface of the devolo Magic
adapter (see Chapter 4.5 Powerline)
or
b Using devolo Cockpit or the
devolo Home Network App. For more infor-
mation, refer to the chapter. 3.4 Installation of
devolo software
3.3.4Establish a Wi-Fi connection with
the devolo Magic 2 WiFi next
Establish the Wi-Fi connection with your laptop,
tablet or smartphone by entering the previously
noted WiFi key as the network security key.
Integrate the Wi-Fi adapter into an existing Wi-
Fi network
To ensure that the devoloMagic2WiFinext has
the same Wi-Fi configuration as your Wi-Fi router,
you can apply the Wi-Fi access data at the touch of
a button using the WiFi Clone function. This can
be enabled in different ways:
To Next Page
Loading...
Need help?
General
Weight and Dimensions
