Page 12 of 63
q Fit nut to threaded rod and tighten until the washer (89) is just clear of
the Snap Ring (86). Be careful not to over tighten.
q Using circlip pliers and a small flat bladed screwdriver prise
the Snap Ring from the groove then maneuver it past the large
groove to clear the Spindle
q Remove the nut and the Three Legged part from the Jig.
q Remove the Snap Ring. (Do Not re-use).
q Lift off the Sliding Sleeve Assembly
q Remove the Washer (89) (Do Not re-use), Remove Rubber Ring (90)
and Locking Ring (92).
To Next Page
Loading...
