Page 34 of 63
Re-assembly of Crank Case , Piston and Gear case.
Jigs Required 559618-99.
Total amount of Grease (800) 83 Grams
5 Grams on the Piston 39 Grams in Gearbox and 39 Grams in Crankcase.
The piston is also available as a SA 579779-00.
Piston (50) 579774-00
Con Rod (38) 487234-00
O Ring (49) 487213-00
Pin (47) 487208-00
Knob (48) x 2 487228-00
q Fit the two white knobs (48) into the ends of the pin (47).
q Grease all around the piston inside and out with 5 Grams of item (800)
Place the smaller diameter of the Con Rod into the piston and push the
Pin through until it is centered.
q Grease the larger diameter hole in the Con Rod.
q Fit O Ring (49) to the Piston
To Next Page
Loading...
