Page 35 of 63
q Refit Piston SA into CrankCase.
q Position the CrankShaft Pin so the Con Rod can be fitted
through the front of. Main Housing. Leave the piston in this
position ready to fit the Anti-Vibration unit.
q Distribute 39 Grams of Item (800) Grease into CrankCase.
q Make sure a new O Ring (52) is fitted then Refit the Cover (53). Tighten Screws to 3 Nm.
q Fit Electronics into the motor cover, line up the ‘D’ in the Module spindle
with the ‘D’ in the Cover.
q Fit the cover to the Main Housing
q Tighten the Screws to 3 Nm
To Next Page
Loading...
