DeWalt D25900K Service Manual

Page 27 of 63
REMOVE BAR FROM UNDERSIDE OF SERVICE JIG 559617-99
q Place Main Housing on to Service Jig
559617-99
q Make sure the pin on the CrankShaft (45)
locates into the recess on the Jig.
q Fit new Armature Seal to Main Housing Use Service Tool
and press 559621-99. Make sure the metal insert is facing
up.
q Wipe Grease (800) into the Metal insert before fitting
Bearing.
q Fit Armature Bearing (35), again using Service tool
559621-99.
q Fit CirClip (34)

DeWalt D25900K Specifications

General

Input power	1500 W
Power source	AC
AC input voltage	230 V
AC input frequency	50 Hz
Impact rate	2040 bpm
Impact energy (max)	25 J
Chuck type	SDS Max

Weight and Dimensions

Weight	9800 g