Page 41 of 63
q Grease the inside of the Front Housing and the outside of the
Cylinder with item (800).
q Fit the Ram (76) into the Cylinder (75) with the O-Ring entering
last. Use the Service Tool 559620-99 to push the Ram down until
it reaches the bottom.
Beware grease will come out of the holes in the Cylinder.
q Make sure the inside of the Cylinder is still coated with Grease.
q Grease the inside of the Housing around the teeth.
q Fit the Cylinder into the Housing (78) with the thinner diameter
first. Push down until the larger diameter sits in the teeth.
This completes the reassemble of the Cylinder and Ram .
To Next Page
Loading...
