Page 61 of 63
q Lightly Grease the Bush (72).
q Fit new O-Ring (71) to the Bush.
q Place the Bush into the Front housing with the O-Ring
facing up.
Make sure the internal components of the Tool Holder do not
fall out when fitting to the Front Housing
q Fit the Tool Holder Unit to the Front Housing lining up
the six screw holes
q Tighten the 6 Screws in this Sequence to 10 Nm.
This competes the Re-assembly of the D25900Hammer.
1
2
3
5
4
6
To Next Page
Loading...
