Cycle Settings
A cycle can be edited by clicking on the cycle name in the Cycles page. The name and
language can be customized for that specic cycle. Changing the language for a cycle will
change the status, stage names, and prompts displayed during that particular cycle.
Tip: If a location has multi-lingual employees, the same cycle can be duplicated and
programmed for dierent languages. For example, in a location with English and Spanish
speaking employees, program White Sheets to the desired settings. Copy that cycle, set that
cycle language to Spanish, and note the name change to Sabanas Blancas. This will allow all
employees to read the necessary prompts and descriptions on the control.
Setting Options Options Description
Fill
Bath Temperature Hot
Warm
Cold
No Fill
Auxiliary Temperature
(Heated Models Only)
No Heat
100F (38C) – 195F
(91C)
Heated models only. Temperature
is programmable in 5
O
F / 3
O
C
increments.
Water Level Low
High
These settings can be controlled
by the electronic pressure sensor.
Soap /
Chemicals
Injection Type 1 – 3 None
Detergent Flush
Softener Flush
Chemical 1-10
Three unique soap options are
available for each stage.
See optional settings for setting
chemical injection details.
Injection Delay 0 – 150 seconds
If Delay Fill is ON this is the time
from when the low water level is met.
If Delay Fill is OFF this represents
the time from start of the stage to
when chemical injection begins.
Injection Duration 1 – 240 seconds The amount of time chemicals will
be injected.
Stages
A stage can also be considered a bath, such as prewash, wash, rinse, etc. Each cycle can
consist of 20 unique stages. Within each stage, the following parameters can be selected.
37
Part # 8533-110-001 11/20
To Next Page
Loading...
Need help?
General
