Tip: See example below for how a custom agitation can be used to create a wet clean cycle.
Injection Source Names
Name specic injection sources to clearly show which chemical is being used in which stage
or cycle.
Delay Fill
With Delay Fill on, the stage does not begin decrementing time until the water level is met.
This ensures the load soaks or agitates the target time, even in cases of low water pressure
and slow lls. The default settings have Delay Fill turned ON.
Delay Spin
Delay Spin can be set to OFF or up to 150 seconds. Delay Spin can be used in slow drain
situations to reduce nuisance Slow Drain error codes. The default settings have Delay Spin
turned OFF.
Parameter Stage 1:
Prewash
Stage 2:
Soak
Stage 3:
Soak
Stage
4: Soak /
Wash
Stage 5:
Rinse
Stage 6:
Final Rinse
Temperature Cold Cold NA NA Cold Cold
Water Level Low High High High High High
Soap None Chemical 1 None None Chemical 5 Chemical 6
Soak Time 0 mins 10 mins 10 mins 10 mins 5 mins 5 mins
Agitate Time 2 mins 2 mins 2 mins 2 mins 2 mins 2 mins
Agitation Type Wet Clean Wet Clean Wet Clean Wet Clean Wet Clean Wet Clean
Drain Method Standard None None Standard Standard Standard
Spin Time 0 mins NA NA 0 mins 2 mins 2 mins
Spin Speed NA NA NA NA 60 G 100 G
Example: Wet Clean
40
Part # 8533-110-001 11/20
To Next Page
Loading...
Need help?
General
