EasyManua.ls Logo

Dexter Laundry T-950 - User Manual

Dexter Laundry T-950
92 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
8514-296-001 REV K page 1
COMMERCIAL WASHERS
MODELS T-300/350/400/450/600/650/750/900/950/1200/1450/1800
VENDED C-SERIES CONTROL
OPERATOR’S MANUAL
INSTALLATION & OPERATION
INSTRUCTIONS
Please read this information and retain for reference.
WARNING - THIS WASHER IS EQUIPPED WITH DEVICES AND FEATURES RELATING TO ITS SAFE
OPERATION. TO AVOID INJURY OR ELECTRICAL SHOCK, DO NOT PERFORM ANY SERVICING UNLESS
QUALIFIED TO DO SO.
IT IS THE RESPONSIBILITY OF THE OWNER TO CHECK THIS EQUIPMENT ON A FREQUENT
BASIS TO ASSURE ITS SAFE OPERATION.
A machine should NOT be allowed to operate if any of the following occur:
- Excessively high water level.
- If machine is not connected to a properly grounded circuit.
- If the door does not remain securely locked during the entire cycle.
- Vibration or shaking from an inadequate mounting or foundation.
WARNING - SAFETY PRECAUTIONS
- Always shut off power and water supply before servicing.
- Do not overload the washer.
- Do not open door when cylinder is in motion or it contains water.
- Do not bypass any safety devices of this washer.
- Do not use volatile or flammable substances in or near this washer.
- Keep all panels in place. They protect against shock and injury and add rigidity to the washer.
PREVENTIVE MAINTENANCE REQUIREMENTS
DAILY
- Check that the loading door remains securely locked and cannot be opened during an entire
cycle.
- Clean the top, front, and sides of the cabinet to remove residue.
- Clean the soap dispenser and lid and check that all dispenser mounting screws are in-place and
tight.
- Check the loading door for leaks. Clean the door seal of all foreign matter.
- Leave the loading door open to aerate the washer when not in use.
QUARTERLY
- Make sure the washer is inoperative by switching off the main power supply.
- Check the V-belts for wear and proper tension.
- Clean lint and other foreign matter from around motor.
- Check all water connections for leaks.
- Check the drain valve for leaking and that it opens properly.
- Wipe and clean the inside of the washer and check that all electrical components are free of
moisture and dust.
- Remove and clean water inlet hose filters. Replace if necessary.
- Check anchor bolts. Retighten if necessary.
IMPORTANT: Replace any and all panels that were removed to perform daily and/or quarterly
maintenance.

Table of Contents

Other manuals for Dexter Laundry T-950

Questions and Answers

  • J
    jill90Sep 12, 2025
    What to do if Dexter Laundry T-950 Washer machine starts and does not operate?
    • R
      Rita ButlerSep 12, 2025
      If your Dexter Laundry Washer starts but doesn't operate, check the yellow enable wires from the relay PCB P13 & motor P14 to the VFD to ensure they are connected. Before removing power from the drive, check the fault code on the VFD. Also, check the orange P-15 wire for a signal from the door switches.
  • M
    Mike NicholsSep 13, 2025
    What to do if no cold water to tub in wash for Dexter Laundry T-950 Washer?
    • C
      candicejonesSep 13, 2025
      If cold water isn't entering the tub during the wash cycle of your Dexter Laundry Washer, check the water valve coil for continuity at its terminals and replace it if there's no continuity. Inspect the water inlet screens for blockages and clean them if necessary. Ensure that the water supply is turned on and operating. Check the black and white wires at the Molex plug on the PCB at the main controller and at the relay PCB. Also, check the pressure switch continuity between terminal contacts; if there's no continuity, inspect the pressure switch hose for obstructions and replace the switch if the hose is clear.
  • M
    Madison BanksDec 3, 2025
    How to fix a Dexter Laundry T-950 that does not start?

    Summary

    Manual Overview

    Safety Precautions

    General safety advice and warnings for operating the washer.

    Preventive Maintenance Requirements

    Daily and quarterly checks for optimal washer performance and longevity.

    Installation Instructions

    Foundation Requirements

    Guidelines for concrete floors and bases to ensure stable washer installation.

    Foundation and Pad Options

    Details on reinforced concrete floors and pad types for installation.

    Machine Anchoring

    Methods and options for securely anchoring the washer to the floor.

    Operating Instructions

    Starting the Washer

    Step-by-step guide to loading, selecting cycles, and starting the washing process.

    Emergency Stop; Safety Door Lock

    Explains the function of the emergency stop button and the safety door lock mechanism.

    Machine Programming Instructions

    Manual Programming

    Instructions for accessing and navigating the programming menus on the washer control.

    Prices Option

    How to set vend prices and coin acceptor values for the washer.

    Cycles Option

    Configuration of bath times, temperatures, and spin speeds for various wash cycles.

    Troubleshooting

    Machine does not start

    Common causes and remedies when the washer fails to power on or initiate.

    Dexter Laundry T-950 Specifications

    General IconGeneral
    ModelT-950
    Control TypeMicroprocessor
    Phase3
    Width46.5 in (1181 mm)
    Depth52.5 in (1334 mm)
    Height57.5 in (1461 mm)

    Related product manuals