Bath Bath Cycle Time (min.) Water Temp Delay Fill Spin Time (min.)
Prewash 0 Cold O 0
Wash 9 Warm O 0
Extended Wash 0 n/a n/a n/a
Rinse 4 Cold O 1
Final Rinse 5 Cold
O
n/a
Extra Rinse Spin n/a n/a n/a 0
Extra Rinse Bath 0 Cold
O
n/a
Final Extract Spin n/a n/a n/a 6
Cycles Option:
This option allows the user to set the bath time and spin time for the “Wash” bath. It also allows the user
to set bath time, water temperature and spin time for “Rinse” and “Final rinse” baths. (Water temperature
for the “Wash” bath is chosen by the customer using the “Hot”, “Warm” and “Cold” buttons on the front of
the machine). For the “Final Spin” it also allows the user to set the spin speed (see additional description
below).
It also allows the user to return the values to factory defaults. To reset all values in the Cycles option to
factory default, press “Enter” when the “DEFAULT” prompt is shown. Press “Enter” again when the “RESET”
prompt is shown to conrm the action.
Figure 5, shown below, shows the sub
menu options for Cycles:
42
Part # 8533-081-001 1/18