Motor Hours:
The motor hours eld shows the accumulated hours of operation for the motor. In many cases, it will match
the cycle hours of the machine. However, separate elds are provided in the event that a motor is replaced
on a machine.
The user can set the motor hours to a designated number. For example, if it is necessary to replace the
control on a machine, the new control could be programmed to show the motor hours that were recorded
by the previously installed control. The individual digits of the hours count can be set by using the “Up” or
“Down” buttons to change the number that is ashing. Once the desired digit of the hours is chosen, press
the “Enter” button to move to the next digit. Once the complete hours are chosen, the “Enter” button must
be held down for 3 seconds to conrm the action.
The user can also return the motor hours to the factory default setting (zero). To reset the motor hours,
press “Enter” when the “DEFAULT” prompt is shown. Press “Enter” again when the “RESET” prompt is
shown to conrm the action.
Cycle Hours:
The cycle hours eld shows the accumulated hours of operation for the washer. In many cases, it will match
the motor hours of the machine. However, separate elds are provided in the event that a motor is replaced
on a machine. See the Motor Hours description for more information.
49
Part # 8533-081-001 1/18
To Next Page
Loading...
Need help?
General
