MODEL BMG-535 GRINDER
SECTION 3 GENERAL
28
OPERATING MANUAL
APRIL 2009
Grinding & Polishing
There are three types of tooling that can be put under the diamond tooling.
The three types are: Diamond Segments
Polycrystalline (PCD) Diamond Segments
Polishing Resins
Diamond Segments
The diamond tools are designed for use on concrete floors.
These tools can be used to prepare a floor prior to coating or
as initial steps in a polishing process.
PCD Diamonds
PCD’s can be used for removing epoxy, coating, and other floor
coatings.
Polishing Resins
Polishing resins are used in the final step of a polishing process.
3.15 DIAMOND TOOLING
For questions about the right set for the right floor treatment
,
use the tool scheme chart below or contact your distributor.
To Next Page
Loading...
