2.Starting up/ Standby/ Sleeping
B. Standby
In standby mode, with the power swit
ch on, wait for the user's operation. It can
be changed to standby mode
by below methods:
a. During robot cleaning, press on main body to enter standby mode.
b. During robot cleaning, press ON/OFF button on remote control.
C. Sleeping
In sleeping mode, the robot can only be waken up from button on main body
or ON/OFF on remote control in order to save power. To turn robot into sleeping
mode from standby mode:
a. Hold on main body for 3 seconds.
b. Robot will automatically enter sleeping mode if there is no command received
for more than 60 seconds.
Product Operation
A. Starting up
a. Switch on the power switch at the right side of the robot.
b. Press on main body or ON/OFF on remote control to start cleaning.
Note: If robot is in sleeping mode, press on main body or ON/OFF on remote
control to wake up the robot from sleeping mode, then press again, the robot
will start cleaning automatically.
11
CLEAN
CLEAN
CLEAN
CLEAN
CLEAN
CLEAN
Product Operation
To Next Page
Loading...
