dibea ZN909 - Motor Error Codes; Battery Removal

Fan overloaded
Left wheel overloaded
Right wheel overloaded
Left and right wheel overloaded
Left side brush overloaded
Left wheel and left side brush overloaded
Right wheel and left side brush overloaded
Left and right wheel, left side brush overleaded
Right side brush overleaded
L01x
L0x1
L0x2
L0x3
L0x4
L0x5
L0x6
L0x7
L0x8
Check if fan is pressed and clean dust bin
Left wheel and right side brush overleaded
L0x9
Right wheel and right side brush overleaded
L0xA
Left and right wheel, right side brush overleaded
L0xB
Left and right side brush overleaded
L0xC
Left wheel, left and right side brush overleaded
L0xD
Right wheel, left and right side brush overleaded
L0xE
L0xF
Check if it is stuck or wired
by obstacles
A. Remove the screws on battery cover with a screw driver.
B. Remove the battery cover.
C. Grasp the insulating tape at two sides of the battery and lift the battery.
D. Unplug the wire connector that links battery and robot.
Troubleshooting
Error Code
Cause Solution
Troubleshooting for motors
Left and right wheel, left and right side brush overleaded
Note: If above solution doesn't work, please try below:
1. Reset the robot by powering off it and then turn on it, and check again.
2. If it still not work after reset the robot, contact the after service.
19
Battery Removal
Troubleshooting