Horizontal-Schrumpfgerät
Horizontal Shrinking Device
HS 1100-P
Copyright © Diebold 2017-04 Ersteller: kh
19.3. LCD-Messages
After switching on the device the
Software version (in picture "v02.1")
and the
Number of shrink cycles (in picture "82")
will be displayed for approx. 3 seconds.
The following messages may appear in the LC display:
ATTENTION! Heating time too long !!
the maximum permissible heating time has been exceeded. Heating of the shrink
chuck will automatically be stopped
• Max. temp. coil, please wait -
the maximum permissible coil temperature has been exceeded. Please wait a few
minutes until the inductor has cooled down
• Max. temp. IGBT, please wait -
the maximum permissible IGBT temperature (transistors in the generator) has
been exceeded. Please wait a few minutes until the IGBTs have cooled down
Fault !! -
a fault has occurred
Overload -
the generator is overloaded
IGBT Error -
an IGBT error has occurred
If error messages continue even after switching the unit off and back on, please contact
the manufacturer.
(Observe the cool down of the generator!)
To Next Page
Loading...