Horizontal-Schrumpfgerät
Horizontal Shrinking Device
HS 1100-P
Copyright © Diebold 2017-04 Ersteller: kh
16.2. Hazards from electric components
The unit contains components with dangerous voltages. Please observe the following
for your own safety:
This unit is to be serviced ONLY by trained personal authorized by the
manufacturer.
Do not allow metal chips or liquids to enter the unit.
Unit should be cleaned regularly.
Only ThermoGrip chucks and quality cutting tools should be used.
16.3. Hazards from hot parts
The very effective form of heating only heats the relevant boundary zones of the shrink
fit chuck with low heat input.
The surface of the shrink fit chuck can heat up to approx. 400°C.
For your own safety, comply with the following safety rules when working with the unit:
Ensure that hot parts cannot be touched by mistake.
Never leave hot “ThermoGrip” chucks uncovered. Remove hot tools
from the coil and place them in their respective cooling positions or in
the Chiller Unit.
Do not place hot tools on flammable surfaces.
When shrinking tools in and out, always wear the supplied gloves for
protection from burns and cuts.
Remove all metallic objects from the environment of the inductive coil!.
During operation, remove all jewelry and keep hands clear of coil.
To Next Page
Loading...