Horizontal-Schrumpfgerät
Horizontal Shrinking Device
HS 1100-P
Copyright © Diebold 2017-04 Ersteller: kh
16. General Safety instructions
For shrink fit chucks a new technique is used, which allows the tool change with the
matching shrink chuck in a convenient, efficient and energy saving method. The
induction generator is built using state of the art technology at the time of delivery and
is reliable. Nevertheless, the equipment may pose a hazard if it is not used by trained or
at least instructed personnel and / or for the intended use. Therefore, please note:
Read the operating manual carefully before initial set-up and operation
of the unit, and become well acquainted with the control elements.
The operating manual is an integral part of the unit, and must be
accessible and understood by all persons working with the unit.
Only trained individuals should be allowed to operate this unit.
The unit may only be operated as specified for and under good working
conditions.
This unit is designed and programmed for the use of Diebold “ThermoGrip” chucks.
When other shrink chuck forms and designs are used, problems may occur, because
shrink parameters are set for Diebold shrink chuck contours.
Only use Diebold shrink fit chucks! For other shrink fit chucks no
warranty can be given.
Unauthorized modifications or repairs to the unit will void warranty. Such modifications
lead to damage of the unit.
16.1. Operating location
The Horizontal Shrinking Device HS 1100-P is a table-top unit.
Place the unit on a clean, dry workbench, in a dust and vibration-free
environment.
Avoid direct sunlight on LCD display.
To Next Page
Loading...