Rev. 1.2 (12.2021) MINI-CUBE | SERVICE MANUAL 29
If the test is completed successfully, the SD CARD is working properly. During these
procedures, a text file is created and then deleted from the SD CARD while all the other
files are kept unchanged.
3.1.3.6 USB host test
Once entered the USB HOST page, the following message will appear:
Figure 27
Insert a properly formatted USB PENDRIVE and press OK to start the test.
If the test is completed successfully, an “OK” message will appear on screen.
PLEASE NOTICE: The Pendrive must be formatted with a FAT32 File System, without any
“EFI” partition. To create a Clean FAT32 PenDrive follow these steps:
• From Windows start the MS-DOS console;
• From the DOS PROMPT launch the command "diskpart";
• Type "list disk" and check the disk to be formatted (The PENDRIVE unit);
• Type "select disk n" where 'n' is the letter of the Pendrive unit to be formatted;
• Type "clean";
• Type "create partition primary";
• Type "format quick fs=fat32";
• Type "exit".
3.1.3.7 Transponder test
Press TRANSPONDER to access the internal TRANSPONDER test page, then press START
to execute the procedures shown in the picture below:
To Next Page
Loading...
