18
19
RESET TO FACTORY DEFAULTS
• Press and hold the button on the 410BT for 15 seconds. This will
remove all app settings, historical information, and any set passwords.
This is the only way to remove a password so try not to forget it!
TECHNICAL ASSISTANCE
Should you encounter any problem(s) with this product or if you do
not understand its many features, please refer to this operating manual
rst. If further assistance is required, DIG offers the following customer
support:
• DIGPRO Technical Service USA: DIG’s Technical Service Team is
available to answer questions in English and Spanish from 8:00 AM to
5:00 PM (PST) Monday-Friday (except holidays) at 1.800.344.2281 or
1.760.727-0914.
• Questions also can be e-mailed to questions@digcorp.com
or faxed to 760.727.0282.
• Specication documents and manuals are available for download at
www.digcorp.com.
• Customer Assistance Outside the USA: Contact your local distributor
FCC
This device complies with FCC and IC radiation exposure limits set forth for an
uncontrolled environment. The device should be installed and operated with
a minimum distance of 20cm between the radiator and your body. This device
must not be collocated or operating in conjunction with any other antenna or
transmitter.
I. Changes or modications not expressly approved by DIG Corporation could
void the user’s authority to operate the equipment.
II. This equipment has been tested and found to comply with the limits for
a Class B digital device, pursuant to Part 15 of the FCC Rules.These limits
are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation.If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one of the
following measures:Reorient or relocate the receiving antenna. Increase the
separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.Consult the dealer or an experienced radio/TV
technician for help.
III. Industry Canada
This device complies with Industry Canadalicence-exemptRSSstandard(s).
Operation is subject to the following two conditions: (1) this device may not
cause interference, and (2) this device must accept any interference, including
interference that may cause undesired operation of the device.
Le présent appareil est conforme auxCNRd’Industrie Canada applicables
aux appareils radio exempts de licence. L’exploitation est autorisée aux deux
conditions suivantes: (1) l’appareil ne doit pas produire de brouillage, et
(2) l’appareil doit accepter tout brouillage radioélectrique subi, même si le
brouillage est susceptible d’en compromettre le fonctionnement.
To Next Page
Loading...
Need help?
General
