Digi CM User Manual

Failure to Boot (Corruption)
Device fails to boot and the READYLEDis not illuminated
Reset device to factory default
The Digi CM and Passport units can be reset to factory defaults by pressing and holding the hardware
factory reset button until the Ready LED on the front panel goes out.
Digi CM factory reset button:
Digi Passport factory reset button:
Follow recovery procedure
If the Digi CM or Passport units still fail to boot up, perform the recovery procedure.
1. Connect the console port on the rear panel of the Digi unit to a serial port on a workstation.
Use an Ethernet cable with a DB-9 adapter (one is shipped with the product and labeled as
console).
Digi CM and Passport Troubleshooting Guide
6

Digi CM Specifications

General

Brand	Digi
Model	CM
Category	Switch
Language	English