For more information about SmartSense visit www.smartsense.co or call 1-866-806-2653
© 1996
-
2018 Digi International Inc. All rights reserved. All other trademarks are the property of their respective owners.
P18
A1/818
Important Usage Information
WARNING:
Changes or modications not expressly approved by SmartSense could void the user’s authority to operate the
equipment.
This device has been designed to operate with the antennas listed below, and having a maximum gain of
-2.53dBi. Antennas not included in this list or having a gain greater than -2.53dBi are strictly prohibited for use
with this device. The required antenna impedance is 50 ohms.
To reduce potential radio interference to other users, the antenna type and its gain should be so chosen that the
equivalent isotropically radiated power (e.i.r.p.) is not more than that permitted for successful communication.
This device complies with FCC and IC radiation exposure limits set forth for an uncontrolled environment. The
device should be installed and operated within a minimum distance of 20cm between the radiator and your
body. This device must not be collocated or operating in conjunction with any other antenna or transmitter.
FCC STATEMENT:
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this
device may not cause harmful interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation.
FCC ID: SZ9TMWIFI440Z
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the interference by one of the following measures.
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that which the receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help.
This device complies with FCC and IC radiation exposure limits set forth for an uncontrolled environment. The
device should be installed and operated with a minimum distance of 20cm between the radiator and your body.
This device must not be collocated or operating in conjunction with any other antenna or transmitter.
To Next Page
Loading...
Need help?
General
