Ethernet Gateway Setup via DHCP
1. Connect the Ethernet Gateway to power using the included power adapter and cable included in the
product box. You will see a blue light ashing as the device boots up. Connect the Internet router to the
Internet port on the Ethernet Gateway using an Ethernet cable (not included). You should see a single blink
on both the LAN and Internet indicator lights after a successful transmission.
2. Open a web browser on your computer and navigate to insights.tempalert.com. Once the page loads, enter
the login credentials that were provided to you at the time of purchase.
3. Set up your preferences, device alerts, and sensor alerts. For more information, please view the Insights User
Manual or visit help.smartsense.co for more set up help, tips, and suggestions for optimal performance.
For more information about SmartSense visit www.smartsense.co or call 1-866-806-2653
© 1996
-
2018 Digi International Inc. All rights reserved. All other trademarks are the property of their respective owners.
P6
A1/818
To Next Page
Loading...
Need help?
General
