3.6
Description
COMMAND DESCRIPTION
*I Caller Identification function (CALLER ID)
*K CTS (C106) during the handshaking
*M MultiSubscriber Number function (MSN)
*S Subaddress function
*X Clock in Off-Line
%A2 CSD call type (V.110 or V.120)
%A3 Select data channel
%C V42bis data compression (see also &U command)
%F Flash eprom upgrade facility
%V Select the command set (AT or V25bis)
%Z1 Global Reset
/N11 Fax and Answering machine incoming call
/R1 Fax and Answering machine enable
/T TEI defination
/Z Delete RAM
!C0 ISDN type of Network
!N1= Store Caller Identification number (CALLER ID)
!N2= Store Multi Subscriber Number (MSN)
!N3= Store Subaddress number
+++ Escape sequence
3.4.2. AT COMMAND SET DESCRIPTION
AT Attention
All the characters following the letters ‘AT’ are commands. In AT command mode Tintoretto
automatically detects the Computer speed and parity format. The Tintoretto will response
using the same speed and parity format of AT command.
Store: n/a Default= n/a
A/ Repeat last command
Cause Tintoretto to repeat the last AT command. This command is neither preceded by AT nor
followed by CR
Store: n/a Default= n/a
A Answer incoming data call
Cause Tintoretto to go off hook and attempt a handshake in answer mode
Store: n/a Default= n/a
D Dial
Instruct to go off-hook and execute the phone number.
D 0-9 Dial the dial string.
To Next Page
Loading...
Need help?
General
