38
10. Cleaning
10.1 Door maintenance and storage
• Finger marks: Use a soft cloth moistened with water, soap or neutral detergent,
and then lightly polish with a soft, dry cloth.
• Stains that may appear after the water with impurities dries: Use a soft cloth
moistened with distilled or ionized water and dry thoroughly with a soft, dry
cloth.
• Greases and oils: Use a soft cloth moistened with isopropyl alcohol. Be careful
not to spread the stain.
• It is necessary to check the fastening of the door supports every six months;
10.2 Maintenance and preservation of the passage
control sensor
• Clean the lenses at least every month. Considering the environmental conditions
of the location and the application, adjust the cleaning frequency according to
the needs.
• If cleaning is done regularly, only water is sufficient.
• Do not use chemicals, bleach or cleaning products for household use.
• If the accumulated dirt is too much, apply neutral soap and use a soft cloth or
soft bristle brush.
• Use neutral soap - when and if necessary.
• For heavier cleanings, use isopropyl alcohol with the help of a soft cloth.
• The lenses are sensitive to abrasion, remember this when cleaning them.
• Be sure to clean the plates properly, soap or alcohol residue can stain the
lenses.
10.3 Maintenance and preservation of dFlow (glass
and stainless steel plates)
• Clean the equipment at least every month. Considering the environmental
conditions of the location and the application, adjust the cleaning frequency
according to the needs.
• If cleaning is done regularly, only a dry cloth is sufficient to remove the dust.
• Do not use chemicals, bleach or cleaning products for household use.
• If the accumulated dirt is too much or if there are stains coming from the users’
use, use isopropyl alcohol with the aid of a soft cloth.
• Brushed stainless steel and glass are sensitive to abrasion, remember this when
cleaning them.
• Be sure to clean the plates properly, soap or alcohol residue can stain the
lenses.
To Next Page
Loading...