Digikeijs DR5000 User Manual

DR5000 DIGICENTRAL
P 23
www.digikeijs.com
4.2 LAN sengs
It is possible to adjust the LAN Sengs through the conguraon soware.
You can reach the sengs by rst nding the assigned IP address in your own router.
You have to enter this IP address in the eld marked ‘IP address’. Next, click on one of the ve opons next to it.
If you don’t know exactly what you are changing exactly, it is not advisable to change the standard sengs. Incorrect changes may result in the non-operaon
of the internal router.
In the opon ‘Protocol’ below the sengs page
you can choose the preferred network protocol
that has to be used to connect external network
applicaons to the DR5000.
XpressNet LAN
Choose this opon to connect external applica-
ons through XpressNet LAN
LocoNet over TCP/IP LBServer
Choose this opon to connect external applica-
ons through LocoNet about TCP/IP
Dr. Command
Choose this opon to connect future Digikeijs
applicaons.
If you get the error message:
“”Access Error : Unauthorised, Access to this
document requires a User ID.””
refer to page 25 for instrucons.

Digikeijs DR5000 Specifications

General

Manufacturer	Digikeijs
Category	Controller
Programming Track Output	Yes
Interface	Ethernet, USB
Protocols	DCC
Connectivity	USB, LAN
Operating Temperature	0°C to 40°C
Storage Temperature	-20°C to 70°C