Digikeijs DR5013 DIGIREVERSE User Manual

DR5013 DIGIREVERSE
P 16
www.digikeijs.com
® R-Bus, B-Bus are trademarks which are registered in the name of Modelleisenbahn GmbH. XpressNet and RS-Bus is a trademark registered in the name of Lenz
Stand 2021-07-06
4.4 Updang the So- and Firmware
The development of the DR5013 soware connues and is constantly being improved. With rmware updates, you can equip the DR5013 with the latest so-
ware. The new rmware is integrated in a new conguraon soware. Before a rmware update is performed, it is recommended to save the current sengs
using the "Import/Export Sengs" funcon.
You must rst install the latest version of the conguraon soware before the current rmware update is available.
Method:
1) Disconnect the DR5013 from the PC.
2) Download the new version from our website.
3) Install the conguraon soware.
4) Connect the DR5013 to the USB cable and the PC.
5) Open the conguraon soware.
6) Go to the USB2.0 menu.
7) Use the "Update DR5013" buon to acvate the rmware update.
IMPORTANT: Do not disconnect the DR5013 from the PC when updang the rmware!
This may cause the DR5013 to become unusable.
IMPORTANT!!! Before the rmware update, the DR50113 automacally saves the sengs.
However, it may happen thata the DR5013 module is reset to the factory sengs. Therefore,
check all sengs of the DR5013 aer an update!

Digikeijs DR5013 DIGIREVERSE Specifications

General

Brand	Digikeijs
Model	DR5013 DIGIREVERSE
Category	Control Unit
Language	English