Digikeijs DR5013 DIGIREVERSE

DR5013 DIGIREVERSE
P 18
www.digikeijs.com
® R-Bus, B-Bus are trademarks which are registered in the name of Modelleisenbahn GmbH. XpressNet and RS-Bus is a trademark registered in the name of Lenz
Stand 2021-07-06
1
2
4.5 LocoNet® Features
1) LocoNet® Feedback Monitor. The dierent colors indicate the dierent feedback busses.
2) Slow Module Timing This opon can be acvated if there are problems with Loconet.
3) RailCom Report. Here you select which LocoNet commands are used to send the RailCom message.
MULTI_SENSE_Standard The original OPC_MULTI_SENSE command is used (Digitrax and Bluecher compable).
There is a restricon of the address ranges "locomove address or block address" when the derailing direcon is sent.
MULTI_SENSE_Long The new OPC_MULTI_SENSE_L command is used: No restricon of the address ranges.
MULTI_SENSE_Both Both commands (Long and Standard) are transmied to the central unit.
4) RailCom Sense direcon. Here you can select how the derailment direcon is reported to the control panel in the case of "MULTI_SENSE_Standard".
o No rerail direcon is transmied.
in Blockadresse The track-laying direcon is transmied in the block address (restricon of the block addresses to a maximum of 2048).
in Lokadresse The track-laying direcon is transmied in the locomove address (restricon of locomove addresses to a maximum of
4095).
5) Accept current sengs.
6) Cancel.
5 6
3
4