29
Factory reset
A factory reset can be performed in order to
change PSU settings to their default values.
This option is located on the bottom of the
SETUP page.
The following parameters will be changed:
• Intensity = 0%, Temperature = 5600K, Sat-
uration = 0%; Hue = 120 degrees.
• DMX personality is set to DS 16.
• All cached Lamp Unit Calibration Tables
(LUTs) will be cleared. The next boot-up
will be slower due to the need to reload all
calibration tables for all connected Light
modules.
• The dimming curve will be set to SQR
(Squared).
This reset will not change:
• The DS MODE setting
• WiFi settings (these are stored in the WiFi
module)
• DMX addresses of light modules (these
are not stored in the PSU)
Upon reboot, Remote=DMX on DS6 will
be automatically changed to WiFi in case a
working WiFi module is positively identified.
Similarly, Remote=WiFi on DS6 will be
automatically changed to Remote=DMX if
a working DMX/RDM module is positively
identified.
DS6 User Manual
2. CONTROL / WiFi page
In DS1, there are no user-swappable
modules, and the Remote=DMX and
Remote=WiFi settings can only be manually
changed.
To check if your PSU needs a software update
Bootloader (BL) software version and Main
Program (MP) software version can both be
revised from this page as well.
To Next Page
Loading...