TIME SYNC MODE
There are four types of time sync modes:
• Server Mode: The operating NVR is set as a Time Sync Server,
which can synchronize the time settings of other NVR(s) that
are connected to it over the same network.
• Client Mode: Input the IP address of a designated NVR or a
PC using Remote Software (C3 CMS) that is serving as a Time
Sync Server in “SYNC SERVER”. The NVR’s time clock will be
synchronized with the designated server by updating at
regular time intervals as set in the “TIME SYNC CYCLE”
setting.
• NTP Server Mode: “pool.ntp.org” is the recommended NTP Server. To activate, set the TIME
ZONE of your local area then click [SYNC NOW].
• GPS Mode: Connect USB type GPS device and click [SYNC NOW]
2.3 HDD Format
Digital Watchdog’s NVRs are shipped with pre-installed HDDs that are formatted and ready to be
used. There is no need to format the HDDs out of the box.
If you have purchased an NVR without local storage included, you will need to
format the HDDs after they have been installed to the NVR.
HDD FULL
Select “Overwrite” or “Stop recording” when HDD is full.
• Overwrite: NVR deletes the oldest data and records new data.
• Stop recording: NVR stops recording.
HDD CHECK
Click ( ) next to each HDD to view full information of each HDD such as model name, serial no,
capacity, bad sector ratio, lifetime (used time) and temperature.
To Next Page
Loading...
