HDD FORMAT
Check the box next to the HDDs you wish to format and press the
“FORMAT” button. If system resources are currently occupied (such
as network connection) during the format process, the format process
may fail. It is recommended to reboot the system to release system
resources and then try to format again.
AUTO DELETE
Set the period when the HDD will automatically delete all recorded data. Select from None (default)
up to 366 days.
1. It may take a few minutes to format the HDD.
2. When the format is done, all data in the HDD will be deleted.
3. The system always reserves some space in each built-in HDD to effectively utilize
2.4 Network
Set up the NVR’s network settings for remote connection.
NETWORK TYPE
Select either STATIC IP or DHCP for dynamic IP. For proper configuration, it is recommended to
assign the NVR a DHCP address and let the NVR auto-discover all the proper network settings, and
then change the Network Type to Static IP and save the changes.
• DHCP: the NVR will automatically configure the network settings according to the current
network requirements. If DHCP is selected, click the ‘IP DETECT’ button to automatically
detect all the network settings.
• STATIC IP: manually enter all necessary network settings. While set to STATIC, the network
settings will not change when prompted by the connected DHCP router or DHCP network
device.
IP ADDRESS
Displays the NVR’s IP address. If DHCP is selected, the IP address will automatically adjust to match
the network’s requirements. If STATIC is selected, the IP address can be manually changed as
needed.
To Next Page
Loading...
