3.11 DST Setting and Image Playback
Daylight Saving Time (DST) starts at 2:00 AM local time on the 2nd Sunday of March and ends at
2:00 AM DST on the 1st Sunday of November. During DST, the NVR’s clock will be adjusted according
to the regional time zone. The NVR’s time will shift one hour after DST starts and restore the time
clock to normal after DST ends.
DST Setting
To enable DST on the NVR, go to SYSTEM > INFORMATION and click “DATE/TIME . Select “USE
DST” to apply the DST time change. (Select the proper Time Zone to activate DST)
DST Image Playback
When there is overlapped data due to DST, the overlapping hour will appear blue in the search bar
during playback.
To p l a y back data from the overlapped hour, select a time in the Intelli-search bar. A “Data Selection”
message will appear. Select whether to play DST data or non-DST data.
To Next Page
Loading...
