2.5 Camera Management
The Camera Management menu allows you to search, register and manage your IP cameras.
See
“3.2 Camera Registration” for more information.
Auto-Configuration (1)
The NVR will scan the network for all supported cameras and automatically register detected cameras
to the available channels. Select the recording mode to apply to all registered cameras and press
[START]. The NVR will search for all cameras under the same network (Router) and register them in
order, automatically.
In cases where there are multiple NVRs on the network, it is recommended to use the Drag & Drop or
advanced configuration options to avoid a camera being connected to multiple NVRs.
Drag & Drop Configuration (2)
The Drag & Drop Configuration scans the network for supported cameras, displaying the results in a
table from which you can manually drag-and-drop cameras into the viewing channels to assign them
to specific channels.
1. Click the [START] button to search for the camera.
2. Select a camera and while clicking on the camera, drag it to a channel to assign it.
3. Click the [APPLY] button to finish the process.
Advanced Configuration (3)
Search the network for cameras and manually configure and register them to the NVR.
To Next Page
Loading...
