3.5 Live Display Mode
Channel Selection
Live camera images will display after powering ON the NVR. The images can be displayed in 1, 4, 9 and
16 split-screen options (some split options may not be available depending to the maximum number of
channels of the NVR). Whenever the screen display mode button ( ) on the Toolbar is
clicked, the screen will change to display the next channel or sequence of channels.
To switch from a multi-channel view to a full-screen, single camera display, double-click on the selected
channel. To return to the previous screen mode, click the left mouse button again.
A “VIDEO LOSS” message will display on the screen when no camera is connected or if a camera is
disconnected suddenly. When a camera is disconnected, a warning sound will emit, depending on the
system’s event alarm settings.
Admin users can set various levels of authorization for each user, to grant or exclude viewing access to
specific channels. If a certain user is not authorized to view a channel, the image will be unavailable
within the viewing screen as shown in the example below.
Icons
In Live Mode, icons will appear on the screen to notify of the system mode or status.
The icons shown at the right-upper corner
of each channel screen
The icons shown at the right-bottom corner on
full-screen mode
Continuous Recording
No HDD detected
Motion Detection Recording
Emergency Recording is in use
Sensor Activated Recording
PTZ is enabled
Continuous + Motion Alarm
Recording
Warning for exceeding temperature
Continuous + Sensor Activated
Recording
Sequence mode is enabled
Motion Detection + Sensor
Activated Recording
Digital zoom is enabled
Emergency Recording
Sensor Activated
Motion Detected
To Next Page
Loading...
