2. Select the channel number to register.
3. Select the protocol (ONVIF and RTSP) of the camera. Registration is available with one of the
following. – IP Address, RTSP URL, or ONVIF URL
4. Input necessary information with the button and click the [GET STREAM] button to get
stream information.
5. Click the [APPLY] button to register the camera.
3.3 Deleting Cameras
To delete a camera, go to Advanced Configuration by clicking [ADVANCED] in Camera
Management (Menu > Record).
1. Non-PoE Camera - Delete ( ) button is always activated. Click on the camera to delete
it from the NVR’s channels.
2. PoE Camera - PoE cameras cannot be deleted while connected to the NVR’s PoE switch.
To delete a PoE camera, unplug the camera from the NVR and click the button when it
is activated.
To Next Page
Loading...
