SUBNET MASK
Subnet Mask address classifies the subnet that the system belongs to. For more information, please
consult your network administrator or your Internet provider.
GATEWAY
This is the IP address of the router or gateway server. It is required when connecting to the NVR
through the external router over the Internet (from another network). For more information, consult
your network administrator or your Internet provider.
DNS SERVER
Enter the IP address of the Domain Name Server. Input the DNS Server information to use DDNS,
Email Notifications and NTP Server. For more information, please consult your network
administrator or your Internet provider.
TCP/IP PORT
(Default – Port 9010) Input the network port number that is used when connecting to the NVR
locally or remotely. If your ISP blocks Port 9010, you may either port forward the blocked port or
change to use a different valid port number (ex, 9020). If there are multiple NVRs connected to the
same local network, it should be considered to assign each NVR to different TCP/IP Ports.
WEB PORT
(Default – Port 80) Input the port number to use when connecting with a Web Browser. If your ISP
blocks Port 80, you may either port forward the blocked port or change to use a different valid web
port number (ex, 8080). If there are multiple NVRs connected to the same local network, it should
be considered to assign each NVR to different Web Ports.
AUTO IP
Displays the system IP which is assigned through Auto-IP automatically.
BANDWIDTH LIMIT
(Default – 100 Mbps) Depending on the setting made by the user, the system can control the data
volume transmitted over a network ranging from 25 kbps up to 1Gbps. This function is effective
when under narrow bandwidth network conditions or when the user wants to limit “network
bandwidth occupied by video transmission” to a certain level.
USE UPnP (Universal Plug and Play)
UPnP (Universal Plug and Play) Port Forwarding: If a UPnP supported router is connected, the NVR
will forward ports automatically after communicating with the router without the need for
complicated port forwarding setup at the router.
Once the PC has discovered the NVR using Network Discovery, double-click on the icon to open the
NVR’s web client. Enter the User ID and Password that is used to log in to the NVR then click
‘Connect’.
1. The maximum number of simultaneous remote connections is 15 users.
2. For the other network settings, such as DDNS, Notification, Mobile Push & PathFinder,
please refer to the “4.5 Network”.
To Next Page
Loading...
