• Client Mode: Input the IP address of a designated NVR or a PC using Remote Software (C3
CMS) that is serving as a Time Sync Server in “SYNC SERVER”. The NVR’s time clock will be
synchronized with the designated server by updating at regular time intervals as set in the
“TIME SYNC CYCLE” setting.
• NTP Server Mode: “pool.ntp.org” is the recommended NTP Server. To activate, set the TIME
ZONE of your local area then click [SYNC NOW].
• GPS Mode: Connect USB type GPS device and click [SYNC NOW]
For the DST settings, please refer to “3.11 DST Time Setting”.
LANGUAGE
Select the display language for the system.
VERSION
View the NVR’s current firmware version and update it to a newer version via USB Memory Stick or
FTP server.
Do not click CANCEL during firmware upgrade. It may cause considerable damage
to the system.
Settings may be changed to factory default. It is recommended to check the settings
and operating conditions of the NVR after the firmware upgrade.
Upgrading system using USB memory stick:
1. Insert a USB drive with the firmware file formatted by FAT/FAT32 in any USB port of the NVR
(compatible with USB 2.0).
2. Select ‘USB’ from the Method drop-down options and press the ‘Scan’ button.
3. Once the system detects the USB drive, it will display the firmware file under ‘CURRENT VER’
and the ‘NEW VER’.
4. Click START to begin the upgrade process.
Upgrading system via FTP server:
1. Select FTP in the drop-down options under ‘Method’.
2. Enter the FTP’s address: FTP.dwcc.tv
and enter the username and password (these should be
filled out automatically). Username: vmaxipplus, password: vmaxipplus.
The FTP server address is subject to change without a prior notice
3. Enter Check Time. The system will automatically check the FTP server for newer firmware
every day at set hours.
4. Click the [OK] button to proceed with the automatic firmware upgrade. After completion, the
system will reboot.
5. Click ‘Check’ to allow the NVR to connect to the FTP server and check the latest Firmware
version. If new firmware is available, the NVR will ask you whether you want to upgrade it or
not.
6. Click ‘OK’ to confirm and click ‘START’ to start upgrading.
To set up the NVR to check for new firmware automatically:
1. Select FTP from the METHOD drop-down options.
2. Make sure the FTP information is entered correctly (see the section above).
3. Enter your convenient time at CHECK TIME and then click the [SAVE] button.
To Next Page
Loading...
