• DISPLAY LINE: Set the number of lines to display on the
screen.
• CLEAR TIME: Set the period to display text on the
screen. Data will be deleted from the screen if no new
data is entered after the set time. If it is set as “0”, the
data will not be deleted (If there is Start Character and
the character is input, current data will be deleted
regardless of the Clear Time setting).
• POSITION: Designate the display position of transaction
data.
• FONT COLOR: Select the font color which will be
displayed on the screen. It will be displayed with the
color that is shown on “SAMPLE TEXT”
• SHOW: Select to display transaction data in the
Playback Mode.
• SCROLL REVERSE: Select to change the direction of scrolling. If it is selected, you can scroll
from the bottom to the top, the latest data is displayed on the top.
PORT SETUP (3)
Open the setup screen for the communication port.
• TYPE: Set up the type of communication port.
o SERIAL: It is for a 1-to-1 connection between
NVR and Transaction Verification device
without Serial Mux.
o MUX: It is for a 1-to-Multi connection
between NVR and Transaction Verification
device
• BAUDRATE: Set BAUDRATE according to the
Transaction Verification device.
• PARITY: Set the parity according to the
connected device.
• DATA BIT: Set DATABIT according to the
connected Transaction Verification device.
• STOP BIT: Set STOPBIT according to the
connected Transaction Verification device.
• TCP/IP PORT: Set the TCP/IP Port number.
To Next Page
Loading...
