Digital Watchdog VMAX IP G4 DW-VG416 T16P Series - Page 68

VMAX
®
IP G4™
68
(Default – Port 9010) Input the network port number that is used when connecting to the NVR
locally or remotely. If your ISP blocks Port 9010, you may either port forward the blocked port or
change to use a different valid port number (ex, 9020). If there are multiple NVRs connected to the
same local network, it should be considered to assign each NVR to different TCP/IP Ports.
WEB PORT
(Default – Port 80) Input the port number to use when connecting with a Web Browser. If your ISP
blocks Port 80, you may either port forward the blocked port or change to use a different valid web
port number (ex, 8080). If there are multiple NVRs connected to the same local network, it should
be considered to assign each NVR to different Web Ports.
AUTO IP
Displays the system IP which is assigned through Auto-IP automatically.
BANDWIDTH LIMIT
(Default – 100 Mbps) Depending on the setting made by the user, the system can control the data
volume transmitted over a network ranging from 25 kbps up to 1Gbps. This function is effective
when under narrow bandwidth network conditions or when the user wants to limit “network
bandwidth occupied by video transmission” to a certain level.
USE UPnP (Universal Plug and Play)
UPnP (Universal Plug and Play) Port Forwarding: If a UPnP supported router is connected, the NVR
will forward ports automatically after communicating with the router without the need for
complicated port forwarding setup at the router.
Once the PC has discovered the NVR using Network Discovery, double-click on the icon to open the
NVR’s web client. Enter the User ID and Password that is used to log in to the NVR then click
‘Connect’.
Note
The maximum number of simultaneous connections is 15 users.
POE SETTING
• SETUP: Manually configure the IP address and subnet mask for the cameras connected
directly to the NVR’s PoE switch.
• STATUS: his option decides the speed mode of the network (10Mbps or 100Mbps) at each
POE port. Users can check the status of the cameras connected directly to the NVR’s PoE
switch and reset all PoE cameras as needed. Select from the options Auto (default), Normal,
or Type-H. When cameras experience a long ping delay or connectivity issues, try setting the
PoE’s setting to Type-H. It is not recommended to have all ports set to Type-H.
o NOTE: this option is not available on 16CH Models. All ports work at 100Mbps mode
only.