the different Distortion Models. This lets you audition different Distor-
tion Models with the current Effect Model. Use the three ring knobs
labeled DIST LEVEL, DIST TONE, and DIST GAIN to adjust the
distortion settings.
3. Once a distortion model has been selected, you can exit Distortion
Model Select mode by pressing the TOE SWITCH again. The Expres-
sion Factory will then return to normal operation with both the effect
and distortion bypassed. (The MODEL knob now might be on a dif-
ferent Effect Model than before it was entered; if so, just turn it back to
the desired Effect Model and press the TOE SWITCH to activate it.)
NOTE: Once Distortion Model Select mode has been exited, the Distor-
tion Model that was selected will be saved off with the Effect Model that
was active when the distortion was selected. This lets you select and save
a specific or different Distortion Model to use with each Effect Model.
For a list of Distortion Models, refer to the Distortion and Cabinet
Models section.
To Next Page
Loading...
