Using the Optional FS3X Footswitch
The Expression Factory
TM
accommodates the optional FS3X 3-button
footswitch.
When an Effect Model or an Effect + Distortion Model is enabled, the
MODE footswitch toggles between Effect Model only (green LED) and
Effect + Distortion Model (red LED), until either the Expression Factory’s
TOE SWITCH (Effect Model) or HEEL SWITCH (Effect Model +
Distortion Model) has been pressed to put the Expression Factory into
bypass.
The DOWN footswitch selects the next model down. Pressing and
holding the DOWN footswitch for three seconds selects Model 1.
The UP footswitch selects the next model up. Pressing and holding the
UP footswitch for three seconds selects Model 7.
NOTE: Use only the stereo TRS cable that ships with the FS3X
Footswitch to connect the Footswitch to the Expression Factory.
To Next Page
Loading...
Need help?
General
