Flexible Output Mode
TM
The Expression Factory
TM
has four Flexible Output Modes: Mono, Stereo
Mixer, Stereo Amp, and Amp/Mixer. These modes let you send a mono sig-
nal to an amp or a mixer, or a stereo signal to two amps or two channels
of a mixer, or a mono signal to an amp and a mixer simultaneously.
Mode 1 (MONO) is automatically selected when only one cable is
plugged into either the OUT 1 (AMP) or OUT 2 (MIXER) output. Mode
2 (STEREO MIXER), Mode 3 (STEREO AMP), and Mode 4 (AMP/MIXER)
are enabled when two cables are plugged into both the OUT 1 (AMP)
and OUT 2 (MIXER) outputs. Mode 2 (STEREO MIXER) is the factory
default stereo output mode. Mode 3 (STEREO AMP) and Mode 4 (AMP/
MIXER) can be enabled using the Flexible Output Mode Setup (Modes
2-4 are all selected using the Flexible Output Mode Setup).
To Next Page
Loading...
Need help?
General
