Selecting and Activating a Distortion Model + Effect
Model
The Expression Factory
TM
has seven Distortion Models that can be
selected using the MODEL knob. This is done by accessing the Distor-
tion Model Select mode. Once this mode is accessed, the MODEL knob
selects a Distortion Model while the rest of the knobs maintain their
labeled functions. To enter Distortion Model Select mode, follow these
steps:
1. Rock the EXPRESSION PEDAL forward and then press and hold
the TOE SWITCH for three seconds until the INDICATOR LED
begins flashing yellow. If the distortion was already active, it will turn
off first, and then turn back on once Distortion Model Select mode is
active.
2. Once the INDICATOR LED begins flashing yellow, use the MODEL
knob to select between the different Distortion Models. The Effect
Model that was selected prior to entering Distortion Model Select
mode remains active and does not change as the MODEL knob selects
To Next Page
Loading...
Need help?
General
