DigiTech GNX2 User Manual

Parameter 2 - The Number 3 knob adjusts the intensity (Depth) of the modulation.Ranges from 1
to 99.
Parameter 3 - The Number 4 knob adjusts the PreDelay (PREDeLaY) or length of time before the
Chorus effect is applied to the input signal.Ranges from 1 to 20.
* Parameter 4 - Selects the waveform used by the Chorus.Waveforms include: Triangle , Sine, and
Square.
* Parameter 5 - Adjusts the left to right balance of the wet signal.Ranges from L 99 to R 99.
Mod Level - The Number 5 knob controls the level (mod levl) of the Chorus.Ranges from 0 to
99.
FLANGER
( flanger)
A Flanger uses the same principle as a Chorus but uses a shorter delay time and adds regeneration
(or repeats) to the modulating delay. This results in an exaggerated up and down sweeping motion to
the effect.
Parameter 1 - The Number 2 knob adjusts the rate (Speed) of the modulation. Ranges from 1 to
99.
Parameter 2 - The Number 3 knob adjusts the intensity (Depth) of the Modulation.Ranges from 1
to 99.
Parameter 3 - The Number 4 knob adjusts the amount of feedback (Regen) added to the Flanger
delay.Ranges from 0 to 99.
* Parameter 4 - Selects the waveform used by the Flanger.Waveforms include: Triangle , Sine, and
Square.
* Parameter 5 - Adjusts the left to right balance of the wet signal.Ranges from L 99 to R 99.
Mod Mix - The Number 5 knob controls the mix (mod mix) of wet and dry signal. Ranges from 0
(all dry) to 99 (all wet).
PHASER
(phaser)
A Phaser splits the incoming signal,and then changes the phasing of the signal. The signal is then taken
in and out of phase and mixed back in with the original signal. As the phasing changes,different fre-
quencies are canceled resulting in a warm sort of twisting sound.
Parameter 1 - The Number 2 knob adjusts the rate (Speed) of the modulating phase.Ranges from
1 to 99.
Parameter 2 - The Number 3 knob adjusts the intensity (Depth) of the modulation.Ranges from 1
to 99.
Parameter 3 - The Number 4 knob adjusts the amount of effected signal returned to the input of
the Phaser (Regen).Ranges from 0 to 99.
* Parameter 4 - Selects the waveform used by the Phaser.Waveforms include: Triangle , Sine, and
Square.
* Parameter 5 - Adjusts the left to right balance of the wet signal.Ranges from L 99 to R 99.
Mod Mix - The Number 5 knob controls the mix (mod mix) of wet and dry signal. Ranges from 0
(all dry) to 99 (all wet).
* These Parameters are only available using the G
ENEDIT™ computer editor software.
23
Effects and Parameters

DigiTech GNX2 Specifications

General

Brand	DigiTech
Model	GNX2
Category	Music Pedal
Language	English