14
Press this button while the Shift button is lit to change the playback
status of a recorded phrase. When the Loop LED is lit the phrase
will play back in an endless loop. When the Single LED is lit, the
phrase will play once and stop.
Dry Defeat (Time Signature) Button12.
Press and hold this button to defeat dry signal through the JamMan
®
Stereo. Dry Defeat should be used when connecting to parallel effects
loops of amps that have them or when the JamMan is used in an Aux
Send of a mixer.
Press this button while the Shift button is lit to change the Time
Signature (see page 40). Note that Time Signature can only be
changed for a memory location that has no phrase recorded in it.
Loop Up Footswitch13.
This footswitch selects the next higher loop memory. Press and hold
this footswitch to scroll quickly through internal and optional SD
card memories.
Tempo/Stop (Hold) Clear Footswitch14.
This footswitch Stops recording, playback and overdubbing of the
phrase. It is also used to set the tempo before recording a loop
or for changing the tempo of a stored loop. Press and hold this
footswitch for two seconds to clear any audio in a loop that has not
been stored. Pressing and holding this footswitch can also restore
the stored tempo if it has been changed.
Rec/Play/Overdub (Hold) Undo Footswitch15.
This footswitch is used for recording, playing, and overdubbing loops.
Pressing and holding this footswitch for two seconds will undo or
redo the last overdub.
Guided Tour - Front Panel
To Next Page
Loading...
